Yes, you will need to seal your ink-jet print with a matte acrylic sealer such as Mod Podge Acrylic Sealer, before using Mod Podge. Spray a very light
coat, let dry and spray again.
Hard
Coat Mod Podge dries clear with a non-tacky surface. If using Gloss, Matte or Satin Mod Podge apply a clear acrylic sealer to the surface after it has cured 4 weeks.
For best results, wait 2 hours between each
coat of paint. Allow 24 hours for paint to fully cure.
Apply Waverly Inspirations Wax using the Wax Brush to work the medium into matte chalk finish paint. Load the brush with small amount of wax, removing any excess. Apply a thin
coat of wax using a downward, circular motion. This motion works wax into the surface, allowing it ...
On heavily used surfaces, it's recommended to reapply a fresh
coat of clear wax once every 6 months to a year. It is not necessary to reapply to decorative or lightly used items.
Yes, FolkArt® Shinys will stick to each other after they have cured. Any paint with a gloss finish will stick to itself. To prevent sticking, apply a
coat of FolkArt® Outdoor Varnish.
FolkArt® Shinys can be applied to unprimed porous surfaces, however, painting on a primed surface will reduce the number of coats required for a shiny finish. The initial
coat on an unprimed surface may not appear shiny because the paint is absorbed into the surface. The sh...
After allowing the first step of Barnwood Tint to thoroughly dry (approximately 4 hours), shake well then apply a small puddle of Barnwood Wax to the palette. Load the FolkArt Shortie Brush with Barnwood Wax and apply a smooth even
coat across the surface. NOTE: If applying ...
Surface preparation depends on the type of surface you've chosen. Wood – Because FolkArt Painted Finishes Moss is a thick textural paint, there is no need for additional prep whether working on finished or unfinished wood, even if the surface is very rough. Terra Cott...
It is not necessary, however, for added protection against dust or dirt, a light
coat or two of Patricia Nimocks Clear Acrylic Sealer (in matte, satin or gloss) may be lightly applied. .tb_button {padding:1px;cursor:pointer;border-right: 1px solid #8b8b8b;border-left: 1px s...