Instructions:
- Following basic instruction on Photo Transfer Medium, apply a thick coat of medium to the PHOTO SIDE of the printout. Apply a thick coat to completely cover the image in white.
- Place the photo onto the tote bad and lightly press making sure all areas are lying flat but do not squeeze the Mod Podge from out the sides.
- Let dry completely.
- PAPER SIDE is up, spray with water and let soak a few min. Rub off the paper lightly with your fingers as you start to see the image appear.
- Repeat until all paper is removed from image and looks like a clean photo.
- Cut fabric pieces larger than the section of bag that you will cover.
- Brush a light coat of fabric Mod Podge onto the back of each fabric piece, let dry. This allows you to cut the patterns with no fraying.
- Place pieces of fabric around photo and measure length to cut each strip to create frame.
- Following basic instructions on Mod Podge Fabric, brush onto the back of fabric and press onto tote bag as shown. Press down all areas making sure fabric is lying flat and all edges are glued down. Let dry.
- Repeat to create frame around photo as shown.
- Let dry completely.
