Email Signup

Subscribe to the PLAID Crafts Newsletter,
and we’ll throw in $10 towards your next purchase.

Bear Photo Transfer Pillow

Create a safer, huggable bear buddy using Mod Podge photo transfer medium and a furry throw pillow.

At a Glance:

#6485 Skill Level: Intermediate Time:
  • Clock active
  • Clock active
  • Clock active
  • Clock active

This project features these great brands:

  • Mod Podge Logo
  • Mod Podge Finishes and Formulas Logo
supplies

Mod Podge ® Brush Applicator, 4"

Number Needed: 1 $0.00 $13.99
Item available exclusively at Walmart

Mod Podge ® Silicone Craft Mat

Number Needed: 1 $0.00 $10.99
Item available exclusively at Walmart

Mod Podge ® Professional Tool Set

Number Needed: 1 $0.00 $8.29
Item available exclusively at Walmart

Mod Podge ® Photo Transfer Medium, 8 oz.

Number Needed: 1 $0.00 $9.99
Item available exclusively at Walmart
instructions

Other Supplies

Wax paper, Foam plate, Muslin fabric, Brown fur fabric, Sponge, Polyfil stuffing, Scissors, Sewing machine, Straight pins, Needle & thread, Measuring tape, Water basin, Paper towels, Bear stock photo

Instructions

  1. Make a color laser copy the size desired. Trim the image.
  2. Cut a piece of muslin fabric 1” larger than your image. Be sure your fabric is smooth and free of wrinkles.
  3. Tear two sheets of wax paper a little larger than your image. Lay beside your Silicone Craft Mat.
  4. Place the photocopy image-side UP on your craft mat.
  5. Squeeze a generous amount of Photo Transfer Medium onto a foam plate. In smooth strokes, apply the medium over the image. Apply a thick coat so that you cannot see the image. Cover the entire image.
  6. Carefully bend the craft mat back to release the image corner. Put your hand underneath the prepared image, lift and place (medium-covered side UP) on a clean piece of wax paper.
  7. Carefully place a piece of fabric over the image. Gently smooth to make contact with the fabric.
  8. Flip the fabric over so the paper is upright. Lay another piece of wax paper over the prepared image. Smooth over the image with a squeegee or brayer. Be sure to press over all of the edges to ensure good contact. Let dry 24 hours.
  9. To reveal the image, press a semi-damp sponge over the image in sections and let the dampness set for 2 minutes. Then rub over the wet paper in a circular motion removing the paper. Repeat until the image is completely revealed. Let dry.
  10. Repeat rubbings may be necessary in parts where the paper is still adhered. Let dry.
  11. Square up the image fabric to have a ½” edge.
  12. Cut the fur backing fabric to size.
  13. Pin both fabric pieces together image facing inside and fur side facing inward. Sew around pillow leaving approx. 5” open.
  14. Turn pillow inside out. Fill with stuffing and whipstitch the opening closed with needle and thread.

Disclaimer: The information found in each project is presented in good faith, but no warranty is given, nor results guaranteed, nor is freedom from any patent to be inferred. Since we have no control over physical conditions surrounding the application of information herein contained, Plaid Enterprises, Inc. disclaims any liability for untoward results.

Important: Please be sure to thoroughly read the instructions for all products, paying particular attention to all cautions and warnings shown to ensure the proper and safe use of the product.

Copyright: All Rights Reserved. No part of this Project may be reproduced in any form without permission in writing, except for your personal use, except by reviewer, who may in reviewing this project, quote brief passages in a magazine or newspaper.

Nature Damask Stenciled Chair
New!
Nature Damask Stenciled Chair
Martha Stewart Crafts Modern Blossoms Jars
New!
Martha Stewart Crafts Modern Blossoms Jars
A Modern Sunflower
New!
A Modern Sunflower
Square Wood Plate painted with Stains
New!
Square Wood Plate painted with Stains