Inbox Inspiration

Subscribe to the PLAID Crafts Newsletter,
and we’ll throw in $10 towards your next purchase.

DIY Wedding Table Number for Beach Wedding

By: Sherrie Ragsdale

This DIY wedding table number is perfect for a destination beach wedding.

At a Glance:

Project #14846 Skill Level: Advanced Time:
  • Clock active
  • Clock active
  • Clock active
  • Clock active

This project features these great brands:

  • Acrylic Paint Logo
supplies

FolkArt ® Acrylic Colors - Linen, 2 oz.

Number Needed: 1 $0.00 $1.59
Item available exclusively at Walmart

FolkArt ® Acrylic Colors - Jamaican Sea, 2 oz.

Number Needed: 1 $0.00 $1.59
Item available exclusively at Walmart

FolkArt ® Acrylic Colors - Wicker White, 2 oz.

Number Needed: 1 $0.00 $1.59
Item available exclusively at Walmart

FolkArt ® Acrylic Colors - Real Brown, 2 oz.

Number Needed: 1 $0.00 $1.59
Item available exclusively at Walmart

Folkart ® Brushes - Stencil, Premium, 5/8"

Number Needed: 1 $0.00 $8.99
Item available exclusively at Walmart

Folkart ® Brush Sets - Artist Variety Set, 10 pc.

Number Needed: 1 $0.00 $7.99
Item available exclusively at Walmart

FolkArt ® Stencil Value Packs - Letter Stencils - Script

Number Needed: 1 $0.00 $5.29
Item available exclusively at Walmart
instructions

Other Supplies

  • Downloadable shell art
  • Natural driftwood chips
  • 6” x 5” Plywood rectangle
  • Craft knife
  • Sandpaper
  • Hot glue
  • Copy paper
  • Clear packing tape

Instructions

  1. Basecoat the plywood rectangles with Real Brown. Allow to dry.
  2. Paint Jamaican Sea over the Real Brown. Allow to dry.
  3. Dry-brush Wicker White over the Jamaican Sea. Once dry, sand through all the colors so you can see a little of each.
  4. Paint the driftwood chips with Wicker White. Once dry, sand to distress and remove any dust.
  5. Print the downloadable shell art. Place tape over the shell and cut out with craft knife.
  6. Place the shell stencil onto the center of the plywood rectangle and stencil the shell.
  7. Stencil the table number onto the shell. Once dry, sand to distress. Remove dust.
  8. Add lines on the shell with the liner brush using Linen.
  9. Glue the driftwood chips to rectangle.
  10. Glue a driftwood chip to the back of the bottom of rectangle to make stand.

Get the Pattern

Disclaimer: The information found in each project is presented in good faith, but no warranty is given, nor results guaranteed, nor is freedom from any patent to be inferred. Since we have no control over physical conditions surrounding the application of information herein contained, Plaid Enterprises, Inc. disclaims any liability for untoward results.

Important: Please be sure to thoroughly read the instructions for all products, paying particular attention to all cautions and warnings shown to ensure the proper and safe use of the product.

Copyright: All Rights Reserved. No part of this Project may be reproduced in any form without permission in writing, except for your personal use, except by reviewer, who may in reviewing this project, quote brief passages in a magazine or newspaper.