Brush basin or container for water, Paper towels, Rubbing alcohol, Foam plate, Scissors, Surfaces
Doily Lace Instructions:
Apply Wisteria, Polar Blue and Key Lime Liquid Fill Transparent with spray system. NOTE: There is no need to use a spray medium when spray painting with Liquid Fill Transparent. Tape off areas where desired before spraying. Apply a second coat if a stronger color is desired. After spraying carefully remove tape using craft knife to score along tape line.
Silkscreen doily designs on glass bottles and ceramic pieces using Gloss Opaque Wedding Cake and Beach Glass Frost Translucent.
Wash glass and ceramic pieces in warm soapy water to thoroughly clean; rinse well and allow to dry.
Moisten paper towel with rubbing alcohol and wipe over cleaned glass to remove any remaining dirt, grease or soap film. Allow to dry.
Apply Frost Translucent and Liquid Fill Translucent paint using spray system.
Peel silkscreen from backing sheet; set backing aside and save for silkscreen storage.
Position silk screen on glass surface where desired; press in place.
Silkscreen Painting Instructions:
Apply paint through silkscreen using either the Squeegee Tool Technique or the Foam Pouncer Tool Technique.
Squeegee Tool Technique – Squeeze a small amount of paint onto solid edge of silkscreen. Holding squeegee tool at a 45° angle with light pressure, pull the paint across the opening of the silkscreen. Continue painting until the entire design area has been silkscreened. Set squeegee aside in container of water for cleaning. While paint is still wet, neatly and carefully lift silkscreen by peeling away from the glass surface. NOTE: Be careful not to drag silkscreen while removing it as your painted design may be blurred.
Foam Pouncer Tool Technique – Squeeze a small amount of paint onto foam plate. Load the flat bottom edge of the foam pouncer with glass paint by dabbing into the puddle of paint. Dab a few times more on a clean spot on the foam plate to ensure you have the entire foam pouncer loaded properly. Holding the foam pouncer as you would a pencil, begin dabbing straight up and down over the opening of the silkscreen. Continue painting until the entire design area has been painted. Set foam pouncer aside in container of water for cleaning. While paint is still wet, neatly and carefully lift silkscreen by peeling away from the glass surface. NOTE: Be careful not to drag silkscreen while removing it as your painted design may be blurred.
Continue adding silkscreen design over glass surface until desired effect is achieved. NOTE: When repeating a design, it is best to clean the silkscreen between uses by rinsing in water and allowing the silkscreen to dry thoroughly.
Set completed project aside for 1 hour to thoroughly dry.
All glass surfaces painted with Martha Stewart Crafts Glass Paints should be cured to increase the paint’s durability on glass or ceramic surfaces. Follow either the Bake to Cure Technique or the Air Cure Technique.
Bake to Cure Technique – Set dry silkscreened glassware into cool oven. Set oven to 350°F and bake for 30 minutes. Glass must heat gradually with the oven to avoid breakage. Do NOT place glass in a hot oven. After 30 minutes, turn the oven off. Allow glass to cool completely in oven. Wait 72 hours before using. NOTE: Glitter Glass Paints should not be baked to cure; only use air cure technique when painting with glitter paints.
Air Cure Technique – Air dry completed project for 21 days before using. NOTE: Glitter Glass Paints should not be baked to cure; only use air cure technique when painting with glitter paints.