Glassware, Brush basin or container for water, Paper towels, Rubbing alcohol
Wedding Glasses Instructions:
1. Martha Stewart Crafts Etching Cream can also be used with stencil tape or glass patterning tape to create borders or backgrounds.
2. Etching cream can also be used with Martha Stewart Crafts Adhesive Silkscreens.
3. The color of etching cream may change; it may deepen in value from a warm caramel color to a milk chocolate color as it is open to the air
1. Wash glass in warm soapy water to thoroughly clean; rinse well and allow to dry.
2. Moisten paper towel with rubbing alcohol and wipe over cleaned glass to remove any remaining dirt, grease or soap film. Allow to dry.
Glass Etching Instructions:
1. Remove adhesive stencil from backing sheet and position on glassware where desired. Press stencil firmly in place. Save backing sheet for stencil storage when project is complete.
2. Using stencil tape, create a protective area around the stencil edges to mask the glass surface NOT to be etched. NOTE: If etching cream touches an area unprotected, that area will be etched.
3. Apply a thick layer of etching cream over the open stencil design areas using the natural bristle brush included in the kit. NOTE: You may also use a palette knife or a handled squeegee to apply a liberal amount of etching cream. Set project aside for 15 minutes.
4. After 15 minute wait, rinse glassware under running water to remove all etching cream. While under running water, remove stencil and stencil tape. NOTE: It is best to wear protective gloves when working with etching cream. Make sure that etching cream does not run over the edge of the design or spill on any areas that are not to be etched.
5. Rinse stencils well, blot dry and return to backing sheet for storage.
6. Dry etched glassware.