HomeProjects Mod Melt Flair Pins

Mod Melt Flair Pins

By: Cathie & Steve

Use the Mod Melt Trinkets Mold to create flair pins to wear, give, or trade.

At a Glance:

Project #14923 Skill Level: Beginner Time:

This project features these great brands:

supplies

Mod Podge ® Mod Melts - White Milk Glass

Number Needed: 1

Mod Podge ® Mod Molds - Trinkets

Number Needed: 1

FolkArt ® Multi-Surface Satin Acrylic Paints - Bright Pink, 2 oz.

Number Needed: 1

instructions

Other Supplies

Tiny rhinestones, Gem glue, Tie-tac pin back, Heavy-duty glue

Instructions

Heat the Mod Melt stick in the Mod Melter. Squeeze the Mod Melt into the heart mold on the Trinkets Mod Mold. Once cool, remove the heart melt from the mold.
Paint the heart with two coats of Bright Pink paint. Once dry, top-coat with Mod Podge Sparkle.
Using gem glue, attach rhinestones around the edge of the heart.
Once dry, glue a pin back to the back of the heart. Allow to dry.

PROJECT TIP: Almost all the molds on the Mod Podge Trinket Mold can be used to create flair pins.

Disclaimer: The information found in each project is presented in good faith, but no warranty is given, nor results guaranteed, nor is freedom from any patent to be inferred. Since we have no control over physical conditions surrounding the application of information herein contained, Plaid Enterprises, Inc. disclaims any liability for untoward results.

Important: Please be sure to thoroughly read the instructions for all products, paying particular attention to all cautions and warnings shown to ensure the proper and safe use of the product.

Copyright: All Rights Reserved. No part of this Project may be reproduced in any form without permission in writing, except for your personal use, except by reviewer, who may in reviewing this project, quote brief passages in a magazine or newspaper.

Shutter Craft Project - Patterned Heart

Gem Studded Hat Box

Chromatic Desk Organizer

Maracas!

Mod Melt Flair Pins