Inbox Inspiration

Subscribe to the PLAID Crafts Newsletter,
and we’ll throw in $10 towards your next purchase.

Werewolf Pumpkin with FolkArt Acrylics

Get ready to hear howls of delight with this spooky creation!

At a Glance:

#5129 Skill Level: Beginner Time:
  • Clock active
  • Clock active
  • Clock active
  • Clock active

This project features these great brands:

  • Acrylic Paint Logo
supplies

FolkArt ® Acrylic Colors - Dove Gray, 2 oz.

Number Needed: 1 $0.00 $1.59
Item available exclusively at Walmart

FolkArt ® Acrylic Colors - Wicker White, 2 oz.

Number Needed: 1 $0.00 $1.59
Item available exclusively at Walmart

FolkArt ® Acrylic Colors - Calico Red, 2 oz.

Number Needed: 1 $0.00 $1.59
Item available exclusively at Walmart

FolkArt ® Acrylic Colors - Licorice, 2 oz.

Number Needed: 1 $0.00 $1.59
Item available exclusively at Walmart
instructions

Other Supplies

BA3S Make It Fun 3” Stryofoam Ball, Creatology White Foam Sheet-2mm, Foam Brush Hot Glue, Flat Brush, Craft Knife, Liner Brush, Paper Towels, Container for Water, Foam Plate

Instructions

  1. Cut out four triangles for ears from the white craft foam. Hot glue two triangles together for a thicker ear. Cut a curve at the bottom of each triangle so that it will fit on pumpkin.
  2. Cut the styrofoam ball in half. Roll one of the halves on its side to make it more like a large tube. Make a triangular shape indention with your fingers on the side. This is the bottom of the snout. Make another indention from the bottom of snout around the end to the top of snout right under the nose.
  3. Basecoat the pumpkin, snout and the ears with Dove Gray. Allow to dry. Dry brush Licorice on all over the pumpkin and snout.
  4. Figure out the placement for the snout. Using the liner brush, paint a Licorice “U” shape for mouth. Make sure it is going under the snout so you can’t see the ends. Come in a little from the “U” shape and paint the inside of mouth Licorice. Allow it to dry.
  5. Paint Wicker White teeth and cut out triangles for teeth.from white craft foam. Hot glue the foam teeth into the bottom of the snout.
  6. Paint the nose, eyes and inside of ears with Licorice. Allow to dry. Paint the inside of eyes with Calico Red.
  7. Glue the ears and snout in place. Cut black pipe cleaner a little longer then the eyes and glue into place.

Disclaimer: The information found in each project is presented in good faith, but no warranty is given, nor results guaranteed, nor is freedom from any patent to be inferred. Since we have no control over physical conditions surrounding the application of information herein contained, Plaid Enterprises, Inc. disclaims any liability for untoward results.

Important: Please be sure to thoroughly read the instructions for all products, paying particular attention to all cautions and warnings shown to ensure the proper and safe use of the product.

Copyright: All Rights Reserved. No part of this Project may be reproduced in any form without permission in writing, except for your personal use, except by reviewer, who may in reviewing this project, quote brief passages in a magazine or newspaper.