"Proud Dog Mom" Pillow

Other Supplies

• Downloadable art – “Proud Dog Mom”
• Blank decorative pillowcase
• Pillow form
• Wax paper
• Scissors
• Sponge
• Paper plate, Water basin

Instructions

1. Prep the pillow case by pressing out any wrinkles.
2. Print the downloadable art with the words reversed with a laser printer. Trim around the artwork leaving a slight white edge of paper.
3. Place the artwork FACE UP on a sheet of wax paper. Generously coat the front of artwork using the foam brush.
4. Carefully release the artwork from the wax paper and hold by the edges. Place face down on the center of the pillow case. Using the brayer or squeegee, smooth the artwork to the case and remove any excess transfer medium with a paper towel. Note: If some transfer medium remains it will dry clear.
5. Let dry 24 hours.
6. To remove paper from dried design, press with damp sponge and let sit for 2 minutes. Rub off paper design using circular motions. Rinse sponge and repeat until all paper is removed.
7. Apply a coat of Burnt Umber to your dog’s paw using a sponge and press in place on the artwork between the D and G. Clean paw with soap and water.
8. Add pillow form.

• NOTE: This pillow case is for decorative purposes only and should not be laundered.