Upcycled Coffee Bar

1. Remove doors and any inside component that doesn't make sense.  Make sure to hold on to the electical outlets that where located on the inside.  Place them to the side.
2. Fill any holes left by screws with wood filler.  Once wood filler is dry sand it down until flush with surface.
3.  Measure the inside dimensions to determine the size of the shelf.  Cut shelf from the 1/2" plywood.  Sand rough edges.
4. Cut a set of 2" wide strips from the 1/2" birch plywood.  Then cut these pieces to the depth of the inside of the armoire.  These will be the two braces that hold the shelf up.
5. Determine where the shelf will sit on the inside and screw the two strips, one on each side, in place. 
6.  Measure the between the top of the shelf to the bottom of the top on the inside of cabinet.  Measure the width.  Cut the 1/4" plywood to these dimensions.  Sand any rough edges.
7. The doors from this armoire were easy to cut in half to make a sign.  Not all doors will be made this way.  If that is the case then buy a unfinished wooden sign and paint it in the same way.
8. Begin to basecoat the cabinet with Castle.  Paint the shelf as well.  Sand in between coats.
9. Paint the 1/4" backing with White Adirondack.  Allow the white to dry and then add the black marks with one of the round brushes from the pack of brushes listed in supply list.

Glue the backing to the back of the armoire.Add some finishing nails to hold it in place. Apply a coat of clear wax to the cabinet and the shelf.Allow to dry and then use the soft cloth to buff.Drill a 1" hole with the paddle bit at the bottom where the electical cord will be running. Screw the electical outlet onto the back of the cabinet where the coffee pot is going to sits.

10. Put the shelf in place.
11. Paint the frame of the sign with Treasure Gold and the back of sign with Black.  Once dry. Stencil       "COFFEE BAR" in White Adirondack. 
13. Tape off a 2" border at the top edge of the large tray located under the shelf of the Coffee Bar.   Paint above the tape with White Adirondack.  Once dry add the Black marks to the painted border.
14. For the light fixture, make a hole in the bottom of the wooden bowl large enough for the plug from the hanging pendant to fit though.  This can be done with the jigsaw or by using the large paddle bit in the drill.  Pull the cord from the bottom, through the hole and out the top, which is actually the bottom of the bowl.
15. Find the center of the underside of the top.  Screw in a cup hook
16. Screw another cup hook in to back upper corner. 
17. Drape the light fixture as seen in the photo.  Plug the light into the electical outlet attached to the inside of cabinet.

Watch a Video Tutorial

@plaidcrafts

Armoire to Coffee Bar! #refinishrelove #folkart #homedecorchalk #chalkpaint #coffeebar #diy #furnituremakeover #diyfurniture

♬ original sound - Plaid Crafts