Take your dog everywhere you go with Mod Podge Image Transfer!
Instructions
Preparation:
- Print desired art that can be found by searching images on the internet. Be use to use a laser printer not an inkjet printer. Using scissors, cut close to the design lines of the image.
Instructions:
- Apply a liberal amount of Mod Podge Photo Transfer Medium to the front side of the laser printed image. White still wet, flip the image over and carefully position the image onto the canvas tote bag where desired, keeping the Transfer Medium side of the image next to the canvas bag. Press in place, smoothing any air pockets or wrinkles to the edges. Remove any excess Transfer Medium that may be squeezed to the edges. Allow to thoroughly dry.
- Once dry, wet the paper back of the image and carefully rub to remove paper fibers. Continue carefully working the wet paper, removing it until the entire image has been revealed. NOTE: This may be accomplished in a couple wet and then dry sessions rather than all in once session.
