No need to be afraid of this adorable black cat photo transfer project with its adorable black and white plaid ribbon bow! Using Mod Podge Photo Transfer Medium, this project is quick and easy.
Instructions
Preparation:- Print desired black cat art that can be found by searching images on the internet. Be use to use a laser printer not an inkjet printer. Using scissors, cut close to the design lines of the cat.
Instructions:
- Apply a liberal amount of Mod Podge Photo Transfer Medium to the front side of the laser printed cat image. White still wet, flip the image over and carefully position the image onto the canvas tote bag where desired, keeping the Transfer Medium side of the image next to the canvas bag. Press in place, smoothing any air pockets or wrinkles to the edges. Remove any excess Transfer Medium that may be squeezed to the edges. Allow to thoroughly dry.
- Once dry, wet the paper back of the image and carefully rub to remove paper fibers. Continue carefully working the wet paper, removing it until the entire black cat image has been revealed. NOTE: This may be accomplished in a couple wet and then dry sessions rather than all in once session.
- Tie a bow from the black and white plaid ribbon and attach to the neck of the cat’s neck using a safety pin from inside the bag. Enjoy!
