Wicked Halloween Necklace with Mod Podge

Instructions

1. Begin with a rectangle Pendant Tray. Choose your background paper. Trim the paper to fit inside the pendant tray. Use layers of paper if desired.
2. Apply a thin coat of Mod Podge to the pendant tray and to the back of the background paper. Position the background paper in the tray. Smooth with your fingers. Apply a top-coat of Mod Podge.
3. Using Mod Podge as a glue, attach gems to the design around the edge of the pendant well. Allow to dry for 2 hours.
4. Fill in the pendant with Dimensional Magic. Begin around the outer edge and fill until the entire pendant is covered. Dry for 24 hours in an undisturbed and non-drafty place.
5. Create the necklace by first laying out all your beaded chain. Begin by attaching a clasp to the chain with jumprings.
6. Attach a jumpring to the bail on the pendant. Attach the pendant to the chain.
7. Make beaded dangles by threading beads onto long headpins. Leaving enough room for making a loop, trim the end of the headpin. Using pliers, bend back the clipped end to form a loop, attach the loop to the pendant jumpring. Make as many as you wish. For this design we made 5 dangles.

Tip: While the Dimensional Magic is drying don’t move the pendant around or you might get air bubbles. If you do get an air bubble, use a sewing pin to pop it.