Burlap stocking, Paintbrush, Black cotton fabric, Black faux fur, Gold trims
Measure around the top of the stocking. Add two inches to the measurement for overlapping in the back. Trim the faux fur to 5-inches high by the determined measurement.
Using the Mod Melter and Mod Melt Sticks, glue hem the top and bottom edge of the fur. The hem should be about 1 inch deep. Next, working on the fur side, glue gold trim across the lower section of the fur.
Glue the fur to the top of the stocking. Begin and finish in the back for a clean look.
Cut a letter from the black cotton fabric. Apply Fabric Mod Podge to the back of the letter and place in the center/middle of the stocking. Smooth with your fingers to remove any air-bubbles. Allow to dry for 4 hours.
PROJECT TIP: Stencil it! Use a stencil and FolkArt paint to add a name or initial to a stocking.