To fully incorporate the product, Mod Podge Ultra should be gently shaken for 15 seconds prior to use.
It is always best to “test spray,” away from the project surface, before actually spraying Mod Podge Ultra onto the project surface. Prime the nozzle with a few pumps before spraying over the project.
Layer the work surface with newspapers or a drop cloth and/or elevate the project from the work table using bottle caps or position your project over a wire rack.
Mod Podge Ultra is best applied to a project surface by evenly spraying the surface while moving the bottle left to right. Work in small sections at a time to fully wet the surface. Immediately place all design elements onto the wet surface. To prevent an excess application an...
After applying Mod Podge Ultra, the project surface may take four to 24 hours to thoroughly dry. It is best to keep the project surface flat until the Mod Podge Ultra has set. Once set and thoroughly dry, all 3D items will be secure.
Mod Podge Ultra can be used as a topcoat once the project surface is thoroughly dry. Simply spray, brush-on, or pour an additional application for an added scratch-resistant, durable finish.
With a medium coat of Mod Podge Ultra, the project should cure within 24 hours. Allow for longer curing times if applying thicker coats.
Mod Podge Ultra is formulated to dry non-tacky and will not leave a sticky finish.
Yes, Mod Podge Ultra can be use on both indoor and outdoor project surfaces as it is water-resistant and offers UV protection.
If applicators or brushes were used to apply Mod Podge Ultra, clean all tools immediately after use, while still wet, using soap and water. NOTE: It is also best to remove the nozzle spray head from the bottle to thoroughly clean it immediately after each use by rinsing the no...