Clean applicators while wet with soap and water.
When buffing, it is best to use a soft, lint-free cloth. Fold the cloth into a small section which can be easily held in one hand. If working on a large piece of furniture, you will need to open the buffing cloth and refold it to a clean spot several times.
FolkArt Laser-Cut Painting Stencils work beautifully on many decorative craft painting surfaces including wood, tin, paper mache, terra cotta, canvas, plaster and fabric.
You can stencil on either side of a
FolkArt Laser-Cut Painting Stencil. If using a stencil brush to stencil on a slick surface, you may find the brush glides better when stenciling on the slick side of the stencil. Remember, when some stencils are flipped, they will produce a...
Yes, you can use a die-cut machine to cut a
FolkArt Peel & Stick Painting Stencil Blank.
No,
FolkArt® Extreme Glitter will not rub off or flake off of your project. The base of Extreme Glitter is formulated so that glitter particles are securely adhered to the surface once dry.
FolkArt® Extreme Glitter can be used on most porous surfaces including wood, terra cotta and paper mache. It can be used on glass, ceramics for fabric (decorative fabric only).
FolkArt® Extreme Glitter should be applied in thin coats using the tip of a soft bristle brush. A foam brush may also be used, however, some glitter particles may remain in the brush instead of adhering to the project.
If
FolkArt® Extreme Glitter starts to streak, allow that coat to dry to the touch - approximately 20 minutes - then brush another thin coat in the opposite direction using a soft bristle brush.
Allow
FolkArt® Extreme Glitter to dry at least 20 minutes between coats or until the base is clear.