Other Supplies
Two 11” x 11” pine plaques – by Walnut
Hollow X7145 Item #24005, Round foam Spouncer® brushes – ¼” and ¾”, Ruler, Pencil, Paintbrushes – ½” and ¾” flat; #6 filbert; and #8 shader, Foam plate for paints
Instructions
-
Use large flat brush and one coat of Wicker White to basecoat plaques; let dry.
-
Use small flat brush and Licorice to paint side rims of plaques; let dry.
-
Transfer dump truck pattern to one plaque, placing ground line 2” from lower left corner; transfer bulldozer pattern to remaining plaque, with ground line 4” from lower left.
-
Use Calypso Sky to paint sky areas on both plaques; let dry.
-
Use ¼” Spouncer and mixture of one part white to four parts Calypso blue to paint dot pattern on sky area; let dry.
-
Use end of paintbrush handle dipped into Engine Red to paint small dots at center of larger dots on sky; let dry.
-
Refer to photo for placement and use the following colors to paint designs. Dump truck: Tires – Licorice, Wheels – Engine Red, Dumpster – Yellow, Custard Dumpster insets – Pure Orange, Cab – Lemon Custard, Truck bed – Grass Green, Ground and dirt load – Maple Syrup, Bulldozer: Tires – Licorice ,Bucket/cab – Pure Orange, Body – Engine Red, Bucket dirt – Maple Syrup, Ground – Grass Green
-
Use ¼” Spouncer dipped into Pure Orange to paint dot over center of wheels on both designs; let dry.
-
Use ¾” Spouncer and Grass Green to paint border of dots across Dump Truck plaque, approximately ¼” from bottom edge: repeat process on Bulldozer plaque, using Maple Syrup paint.
-
Use end of paintbrush handle dipped into Engine Red to paint dots at center of large border dots; let dry.